General discussion board about VAMs, but no buy/sell offers
All posts to this forum must abide by the posting rules
. Continued posting to any VAMWorld forum constitutes acceptance of the rules.
- Site Admin
- Posts: 4099
- Joined: Mon May 28, 2018 1:57 am
It's an overpolished die. Could be a brand new die that was just polished too much before being used.
Welcome to the VAMWorld 2.0 discussion boards. R.I.P. old VAMWorld.
- Posts: 18
- Joined: Mon Apr 25, 2022 1:38 am
Thanks very much. It is interesting in that the die does not look old otherwise so your explanation makes sense for sure.
- Posts: 1221
- Joined: Mon Nov 04, 2019 2:30 pm
The final step in die manufacture was a dip in acid to remove "fire scale" from final hardening and tempering. Working dies were not normally polished before first use unless there was a lingering defect.