O.T. Washington 'Jetpack' lamination Error

General discussion board about VAMs, but no buy/sell offers
Post Reply
Geseas
Posts: 264
Joined: Sun Aug 11, 2019 2:49 am
Location: West Michigan

O.T. Washington 'Jetpack' lamination Error

Post by Geseas » Sat Jul 31, 2021 8:42 pm

share2.JPG
share2.JPG (246.91 KiB) Viewed 258 times
I believe what we may have is a lamination error where the contaminate that caused the problem
has leached out over time creating a contrail. It must have been some nasty stuff
to stain out like that... Just my guess; any ideas what may be happening? It is not a Morgan, but it is silver.

...makes me laugh,
gcs_lines_qua.jpg
gcs_lines_qua.jpg (249.93 KiB) Viewed 277 times
looks like it is blasting off!

Those scratches in the above photo appear to me to be in the die. I can not see them with a loupe; just the camera. An attempt to clean up a die break?

What happens when a weak planchet encounters a powerful sucking die crack/break?
gcs_lines_quarter.jpg
gcs_lines_quarter.jpg (227.44 KiB) Viewed 238 times
Attachments
jet port at 61.jpg
jet port at 61.jpg (194.32 KiB) Viewed 283 times

Post Reply