General discussion board about VAMs, but no buy/sell offers
11 posts • Page 1 of 1
This 1926-D has die break through LL on reverse (VAM-1H based on that) but the obverse has large rust patches at numerous locations and a die break from bottom of T through Y to rim. There is no mention of a rusted obverse die, pitting, or excessive die wear in the 1H listing. So, I am wondering if this can be a new die pair. I am presenting lots of photos.
- 1926-D left obverse.jpg (131.42 KiB) Viewed 3945 times
- 1926-D die break LL.JPG (164.87 KiB) Viewed 3945 times
- 1926-D rust and break at T-Y .jpg (163.08 KiB) Viewed 3945 times
- 1926-D rust B-E.jpg (112.6 KiB) Viewed 3945 times
- 1926-D rust date.jpg (125.64 KiB) Viewed 3945 times
There also appears to be a long, raised rectangular swath from bottom of T, through bun, to second ray from the right. This is difficult to photograph but I provided two. It appears to be a continuation of the die break but cuts across the bun and hair at 45 degree angle at the base of the T.
- 1926-D hair gouge.jpg (133.17 KiB) Viewed 3939 times
- 1926-D obv hair gouge.jpg (114.41 KiB) Viewed 3939 times
I looked at “planchet” in the VW definitions section and saw two kinds of planchet issues. First is a cracked planchet. That’s not the issue on this coin. Second is planchet lamination. The rectangular swath through the bun and hair may be lamination. Everything else looks like rusty die impressions, but someone with more experience has to jump in here.
This. Glue on a coin can also look like this, but It seems that this is just a damaged coin.
Welcome to the VAMWorld 2.0 discussion boards. R.I.P. old VAMWorld.
It’s not pitting or rust because the areas aren’t raised on the coin. It’s frightening that my mind failed to register this most basic fact. Also, as I read in Definitions, pitting and rust are also more likely to occur more on the reverse because that die faces up and is more likely therefore to hold water. I appreciate the feedback; what seems so obvious to Raybob et.al. was completely missed by me.